schumy7
该用户已被删除
|
1楼
大 中
小 发表于 2007-2-23 20:20 显示全部帖子
!!!全体会员请注意!!!
任何VIP优惠活动,都是骗人的!
切勿上当受骗!
请大家记住并收藏备用访问地址:
地址一
地址二
地址三
地址四
地址五
忘记地址,请发email索取:
getsisurl#gmail.com(#换成@)
【手机】W850i 从内到外
送给那些想知道自己W850里面张什么样子的朋友。或者可能有人想自己给手机换壳的。
其实索爱的手机里面都很像,想拆其它机的朋友也可以参照这个例子。
Sony Ericsson W850i disassembly
Tools required: Torx 6 screwdriver, Size 0 Phillips screwdriver
- Remove the two screws at the bottom of the phone with the torx 6 screwdriver.

- Next push the slider up so you have access to the metal plate, shown below. Run your finger around the edge where the metal plate meets the housing to unclip it.

- With the metal plater removed you have access to two more torx 6 screws. Remove these

- Run your fingernail all the way around the edge of the housing to release it

- The phone will now be in two parts, as below

- The screen assembly is held on by two clips at each side of the phone, indicated below. Unclip them

- Unclip the board for the keypad by lifting it from the right side. It attaches to two ribbons like a plug and socket. The screen ribbon is also attached to the back of this board: also detach this.

- Your phone should now look like the picture below







- Reverse the whole procedure for reassembly
|